Electrolux EDW 1503 - Page 39

8.3.5. EDW 1503 Service function / additional rinsing process
General information Calling above-mentioned service function
w
Calling the Service Functions is similar with all designs
Calling the function "Additional Wash Cycle"
or key arrangements.
w
Always use the keys S0
, S1, S2 and S3 independently
1.
Appliance should be switched off
from their program assignment depending on the model.
w
In service function mode, you can ALWAYS call the
2.
Simultaneously press S1 and S3 and ...
"additional wash cycle" by using keys S1 and S2.
Use key S1 to modify the setting.
3. / 4.
... switch on the appliance with ON/OFF switch S0.
w From works settings, no additional wash cycle is set.
Keep keys S1 and S3 pressed simultaneously until the
3 acknowledging LEDs LD1
, LD2 and LD3 are flashing.
( Short-time illumination of LEDs is possible and does not constitute any fault)
5.
Simultaneously press S1 and S2 until the acknowleding
LED-LD1
is flashing. LEDs LD2 and LD3 will go dark.
The current status whether the Add. Wash Cycle is active or
w
If this function is activated, an additional wash cycle
not is indicated in the display.
is ALWAYS added, except for "prewash extra".
1A = Add. Wash Cycle is selected
This will extend program run times up to
0A = No Add. Wash Cycle
about 10 minutes. This additional wash cycle will be
executed until the function is deactivated again.
Switching this function on or off:
6. / 7.
Any further activation of function key S1 will switch the
addition alternately on or off.
Leaving the function
After the last key pressure of the function key S1 you
can leave the special program as follows.
After 60 seconds all LEDs of the program and option keys
are lit automatically. The indication in the display goes out.
The appliance is in the "prestart" mode again
or
Always applicable:
the appliance is switched off by ON/OFF key S0.
In order to call the totality of service functions, always first
press the function keys S1
and S3 prior to switching the
Saving the set condition
appliance on by means of ON/OFF switch S0!
The currently valid condition is saved directly after any entry.
Keep the keys pressed for abt. 4 seconds in order to activate
will be saved.
the function. This procedure is intentionally distinguished
from those for the customer functions.
ATTENTION: In case of reduced key assemblies
be sure to observe Description Page B 1.
EDW 1503 / VGA
LD1
LD2 LD3
S1 S2 S3
1 99
S0
2.
S1 S3
1.
S0
LD1 LD2 LD3 LD4 LD5 LD6
S1
S2 S3 S4 S5 S6
LD10
LD11
LD12
3.
S1 S3 S0
3-4 seconds
4.
S1 S3 S0
LD1 LD2 LD3
all flashing
... automatically OFF after 60 sec
S0
S0
... OFF by actuating ON/OFF manually
LD1 LD2 LD3 LD4 LD5 LD6
5.
0A
LD1
S1
S2
display and LED are flashing
6.
1A
7.
LD1
S1
0A
LD1
S1
display and LED are flashing
display and LED are flashing