- 54 -
.
10. The new options
Selection by using option key " 3 in 1 "
General information
If you add option 3 in 1 to a wash cycle...
... water hardness setting is automatically adjusted to lowest grade
(water hardness 1) device-internally.
There is no regeneration.
... LED salt is switched off
... rinse-aid dosing is switched off.
... LED rinse-aid is switched off.
To which programmes can you add this option?
"3 in 1 can be selected with all wash cycles, except for the two programmes
... prewash extra
... warm plates
What are the changes during the programme run?
All short cycles (such as E-L-R,...) are prolonged by about 5 to 7 minutes.
All intermediate wash cycles are also shorter.
Rinse-aid is with at least 65°C or 68°C.
Drying time is reduced by about 10 to 20 minutes if possible.
All Energylabel programmes (AAx, BAB,...) contain at least one cleaning temperature of 55°C.
Selection by using option key - Satinize
To which programmes can you add this option?
"Sanitize" can be added to all wash cycles
What are the changes during the programme run?
In the last wash cycle, heating up to 68^C and maintaining this temperature for at least 10 minutes.
This brings about a longer programme run time depending on the programme and the temperature
each.
To Next Page
Loading...
