EDW1510 / EDW1750
Technical Support – RA
Chapter
3
3. Switching off the appliance will exit Service mode.
Enable/disable Pulse Wash
After accessed Service mode (L1, L2 and L3 blinking):
1. Press button S2+S3 to enter this function.
L2 blinks indicating it is in Pulse Wash setting mode.
Display show the current setting of Pulse Wash. “0P” for
disabled, “1P” for enabled
2. Press button S2 to change the setting
3. Switching off the appliance will exit Service mode.
To Previous Page