Electrolux EES27100L User Manual

The light related to indicates the
current setting value:
• For the settings with two values
(on and off), the light is either on
(= the setting is on) or off (= the
setting is off).
• For the settings with multiple
values (levels), the light flashes.
The number of flashes indicates
the current setting value (e.g. 5
flashes + pause + 5 flashes... =
level 5).
2. Press OK to enter the setting.
• The indicator related to the setting
is on.
• The other indicators are off.
• The light related to
indicates
the current setting value.
3. Press Previous or Next to change
the value.
4. Press OK to confirm the setting.
• The new setting is saved.
• The appliance returns to the
setting selection.
5. Press and hold simultaneously
and for about 3
seconds to exit setting mode.
The appliance returns to the programme
selection.
The saved settings remain valid until you
change them again.
7. BEFORE FIRST USE
1. Make sure that the current level of
the water softener agrees with the
hardness of the water supply. If
not, adjust the level of the water
softener.
2. Fill the salt container.
3. Fill the rinse aid dispenser.
4. Open the water tap.
5. Start the programme 30min to
remove any residuals from the
manufacturing process. Do not use
detergent and do not put dishes in
the baskets.
After starting the programme, the
appliance recharges the resin in the
water softener for up to 5 minutes. The
washing phase starts only after this
procedure is complete. The procedure is
repeated periodically.
7.1 The salt container
CAUTION!
Use rough salt designed for
dishwashers only. Fine salt
increases the risk of
corrosion.
The salt is used to recharge the resin in
the water softener and to assure good
washing results in daily use.
How to fill the salt container
1. Turn the cap of the salt container
counterclockwise and remove it.
2. Put 1 litre of water in the salt
container (only for the first time).
3. Fill the salt container with 1 kg of salt
(until it is full).
4. Carefully shake the funnel by its
handle to get the last granules inside.
5. Remove the salt around the opening
of the salt container.
6. Turn the cap of the salt container
clockwise to close the salt container.
www.electrolux.com12

Electrolux EES27100L Specifications

General

Current	10 A
Connected load	1950 W
AC input voltage	220 - 240 V
Energy efficiency scale	A+++ to D
Power consumption (off)	0.5 W
Water consumption per cycle	- L
Energy consumption per cycle	1.039 kWh
Drying class	A
Annual water consumption	2772 L
Annual energy consumption	295 kWh
Cycle time	240 min
Noise level	48 dB
AquaStop function	-
Delay start (max)	3 h
Delayed start timer	Yes
Dishwashing programs	Auto, Eco 50°C, Quick, Rinse
Number of place settings	13 place settings
Number of washing programs	6
Number of temperature settings	2
Door color	Not applicable
Cord length	1.5 m
Control type	Touch
Product size	Full size (60 cm)
Appliance placement	Fully built-in
Control panel color	Black
Cutlery compartment type	Basket
Interior light	No

Weight and Dimensions

Width	596 mm
Height	818 mm
Weight	34250 g
Installation compartment depth	550 mm
Installation compartment width	600 mm
Installation compartment height (max)	880 mm
Installation compartment height (min)	820 mm