16
Chimney Stack
The chimney consists of two sections.
The lower chimney measures 700mm and the upper
chimney (with the recirculation grilles on either side)
measures 415mm. The overall installed measurement
is min. 830 - max 1100mm.
Fitting the Chimney
• Position the upper chimney section and x the upper
part to the frame using the 2 screws 12c (2,9 x 6,5)
provided.
• Similarly, position the lower chimney section and
x the lower part to the frame using the 2 screws
12c (2,9 x 6,5) provided.
Fitting the Hood Body
Before xing the hood canopy to the frame:
• Screw the 2 screws 12f half way into the holes
provided in the sides of the bottom of the
frame.
• Remove the grease filters from the hood
canopy.
• Remove any activated charcoal lters.
• Lift the hood canopy and engage the screws
12f in the slots (A) as far as they will go.
• Working from below, x the hood canopy to
the frame (B), using the 4 screws 12q and 4
washers 22 provided, then tighten all the screws
securely.
INSTALLING THE COOKER HOOD
To Next Page
Loading...
