11
MAINTENANCE AND CLEANING
CAUTION!
t Before maintenance or cleaning is carried out,
the canopy rangehood should be disconnected
from the main power supply. Ensure that the
rangehood is switched off at the wall socket and
the plug removed.
t External surfaces are susceptible to scratches
and abrasions, so please follow the cleaning
instructions to ensure the best possible result is
achieved without damage.
t These instructions must be followed to avoid a
risk
Stainless Steel Surface
Clean stainless steel surfaces using non-abrasive cleaning
products that are specifically for use on stainless steel. To
ensure best results also use an even pressure and follow
the grain of the stainless steel. Use of a soft cloth reduces
the risk of scratching. If the cloth is wet ensure that a dry
soft cloth is used to wipe down the surface again reducing
the risk of any surface rust appearing.
Control panel surface
The control panel can be cleaned using warm soapy
water. Ensure the cloth is well wrung before cleaning. Use
a dry soft cloth to remove any excess moisture left after
cleaning.
Removing the metal grease lters
Push the grease filter towards the left side of the unit and
then pull it down.
Hand washing
The mesh filters can be cleaned by hand in warm soapy
water. Soak in warm water and some washing up liquid.
For stubborn grease stains use a soft nylon brush to help
remove these stains. After cleaning ensure that the filters
are completely dry before refitting.
Dishwasher
Place grease filters in the dishwasher. Select the most
powerful washing program and highest temperature, at
least 65°C. Repeat the process. Refit the grease filters
when they are dry. When washing the metal grease filter
in the dishwasher a slig
ht discolouration of the filter can
occur, this does not have any impact on it’s performance.
Changing the lamps
Lamps are long life LED lamps and should not require
service. If there is an issue with lamps please contact
Service. Service contact details shown on page 13.
Charcoal lter
t The charcoal
should only be used if you want to
use the hood in the recirculation function.
t This cannot be cleaned or re-used and as a
general rule, the activated charcoal filter should be
changed once every four months.
Open or fit the charcoal filter as shown in the image below.
t Always specify the hood model code number and
serial number when ordering replacement filters. This
information is shown on the registration plate located
on the inside of this unit.
t Replacement charcoal can be ordered from your
local Spare parts centre, contact details are shown on
page 13.
To Next Page
Loading...
