Electrolux EHH8945FOG - Troubleshooting

Scratches or dark stains on the
glass-ceramic cause no effect on
how the appliance operates.
To remove the dirt:
•–Remove immediately: mel-
ted plastic, plastic foil, and
food with sugar. If not, the dirt
can cause damage to the ap-
pliance.
–
Remove after the appliance
is sufficiently cool: limescale
rings , water rings, fat stains,
shiny metallic discolorations.
Use a special cleaning agent
for glass ceramic.
• The surface of the hob has hori-
zontal grooves. Clean the appli-
ance with a moist cloth and
some detergent with a smooth
movement from left to right.
• At the end rub the appliance
dry with a clean cloth.
6. TROUBLESHOOTING
Problem Possible Remedy
You cannot activate the
appliance or operate it.
Activate the appliance
again and set the heat set-
ting in less than 10 sec-
onds.
You touched 2 or more
sensor fields at the same
time.
Touch only one sensor
field.
The Stop+Go function op-
erates.
Refer to the chapter “Op-
erating instructions”.
There is water or fat stains
on the control panel.
Clean the control panel.
An acoustic signal sounds
and the appliance deacti-
vates.
An acoustic signal sounds
when the appliance is de-
activated.
You put something on one
or more sensor fields.
Remove the object from
the sensor fields.
The appliance deactivates. You put something on the
sensor field
.
Remove the object from
the sensor field.
12
www.electrolux.com