7
Operating the appliance
Switching the appliance on and off
Selecting the cooking zone
3 The decimal point is displayed by the selected
cooking zone. Then a heat setting must be set
for this cooking zone within 6 seconds, other-
wise it must be re-selected.
Setting the heat setting
3 After selecting the cooking zone, briefly re-
lease the sensor field .
3 After 6 seconds with no input the selection is
cancelled and the decimal point goes out. To
set a new setting, select the required cooking
zone again.
Control panel Display
Switch on Touch for 2 seconds
¾ / decimal point flashes
Switch off Touch for 1 second
h / none
Control panel Display
Select Touch
¾ Decimal point lights up
Control field Display
Increase Touch
¾ to Ç
Decrease Touch
Ç to ¾
Switch off Touch and at the same time
¾
To Next Page
Loading...
