34
Autonomy of the full salt container according to the
change in inlet water hardness
Water hardness
The salt con-
tainer must be
filled approxi-
mately every
1
:
Using cycle 2
for 30 cycles/
day. the salt
container must
be filled approx-
imately every:
1
°f °d °e Cycles Days
15 8.4 10.6 2700 90
20 11.2 14 2180 73
25 14 17.6 1575 53
30 16.9 21.1 1035 35
35 19.7 24.6 855 30
40 22.5 28.1 675 23
45 25.2 31.6 450 15
50 28.1 35.1 270 9
The factory setting of max. outlet water hardness is
10 °f/ 5.6 °d/ 7 °e.
1. Considering a rinse time according to the factory settings.
J.7.1 Salt container
The water can only be softened if there is salt in the special
container. The salt container must be filled when the dish-
washer is started the first time and whenever the message SAL
End appears and an audible alarm sounds.
Wash cycles can be started just the same, even if the display
signals no salt; in which case the water used for washing is not
softened.
CAUTION
• Only use coarse salt with a purity level
of 99.8% NaCl. The use of salt with a
lower purity level can cause clogging of
the salt container filter and malfunction-
ing of the water softener.
• Open the salt container only when the
message SAL End is displayed. Open-
ing the cap when the message SAL
End is not displayed can cause spilling
of the saline solution and compromise
correct machine operation.
How to fill the salt container
• Lift the hood and switch off the dishwasher by pressing ON/
Off button.
• Unscrew cap “A“ of the salt container, turning it
counterclockwise.
• Pour approx. 2 kg of coarse salt [NaCl] in container “A“ (an
amount sufficient to fill the salt container up to the rim) using
the special funnel supplied.
• Remove any traces of salt from the filling hole and the
container thread of the closing cap.
NOTE!
The salt container always has water in it, there-
fore it is normal if water comes out during filling.
• Refit the cap of container “A“, turning it clockwise and
making sure it is tight.
CAUTION
Only salt may be placed in the salt
container. Do not introduce any other
chemical substances such as detergent,
rinse aid or descaling agent, since
these would inevitably damage the
appliance. Such damage invalidates
any warranty and relieves the manufac-
turer of all liability.
NOTE!
The message SAL End may appear for several
wash cycles even after topping-up the salt, as the
salt must circulate in the entire system. Correct
operation of the dishwasher is not, however,
affected
To Next Page
Loading...
