Problem Possible cause Remedy
You put too much salt in
the water.
Do not salt boiling water.
Temperature is not visible
on the display.
The display shows a warn‐
ing icon.
The Food Sensor did not
establish connection with
the hob because the
strength of the signal is too
low.
Place the Food Sensor
close to the antenna on the
hob surface, near the cen‐
tre of the hob. Refer to
"Hints and tips".
Something covers the
Food Sensor or the anten‐
na on the hob surface, e.g.
a piece of metal cutlery.
Remove anything that cov‐
ers the antenna. Make
sure you place cookware
in the centre of the cooking
zone. Refer to "Hints and
tips".
The connection between
the Food Sensor and the
antenna was lost.
Make sure nothing covers
the signal. Move the Food
Sensor along the rim of the
pot to adjust its position.
Refer to "Hints and tips".
Other appliances work at
the same frequency and
disturb the connection.
Remove any appliances
that may disturb the con‐
nection. Refer to "Techni‐
cal Data".
Temperature of the food is
different than expected.
The Food Sensor is inser‐
ted incorrectly.
Make sure the measure‐
ment point is situated in
the thickest part of the
food. Refer to the illustra‐
tions in the "Hints and tips"
section.
The hob detects significant
temperature jumps.
You added some water or
changed the pot while
cooking.
Avoid adding water or
changing the pot after a
function starts.
The heat in the pot did not
spread evenly, especially
for thick liquids.
Stir the food frequently.
The pot gets too hot or the
food is overdone too quick‐
ly.
You used a pot which is
too small.
Use pots whose sizes are
appropriate for a given
cooking zone. Refer to
"Technical data".
You cannot activate a
function.
Another function is running
on the same cooking zone,
which prevents the activa‐
tion.
Stop the function before
you activate another.
www.electrolux.com30
To Next Page
Loading...
