Electrolux EKF900 - Delay Brew Time and Features; Setting Delay Brew Time; Aroma Function; Automatic Shut-Off

ENEN
6 7
11. When the brewing process is nished, allow coee to stop dripping and then remove the carafe
to serve.
For a new brewing cycle, switch o the appliance and allow a few minutes for it to cool down. Then
you can rell the water tank.
SETTING DELAY BREW TIME (AUTOMATIC BREWING)
To program your coee maker to brew at a later time, rst check that the time is set correctly.
1. In standby state and the display shows clock time, touch twice to enter the timer setting
mode.
• The display will show the text “TIMER”.
2. While “TIMER” is displayed, repeatedly touch H and M respectively or you can press the key and
hold until the desired brewing time is displayed on screen, then release it.
3. Repeatedly touch to set the desired intensity of aroma.
• The display will show the corresponding symbols.
light mild strong
4. Touch twice to activate the automatic brewing.
• The white indicator light will illuminate.
• You can check the delay brew time by touching .
• To deactivate the automatic brewing, touch again. The display will show clock time.
5. When the delay brew time is reached, your coee maker will begin the brewing cycle.
• The white indicator light will go out whilst the orange indicator light will illuminate.
AROMA FUNCTION
The taste of your coee can be optimised by touching the aroma button .
The aroma button activates a unique brewing process that enhances the avor and aroma of your
coee.
• To activate this function, in the standby state touch . The corresponding symbols will be
displayed. Touch to brew coee.
• To deactivate this function, in the standby state repeatedly touch until all the aroma
symbols disappear from the display.
AUTOMATIC SHUT-OFF
For safety, this coee maker features the automatic shut-o protection.
When a brewing cycle is nshed, the coee maker will automatically turn o after 35 minutes.
CLEANING AND MAINTENANCE
Turn o and unplug the appliance from the mains socket. Allow the appliance to cool
down before cleaning.
• Clean the outside of the appliance with a slightly damp cloth. Dry thoroughly.
• Never immerse the appliance in water.
• Clean the removable parts in warm soapy water with a soft brush or cloth then rinse
them thoroughly.
• Do not use abrasive or chemical cleaning agents.
DESCALING
Regularly descale the appliance using a specic descaler.
1. Fill the tank with water and descaler to the max line. (Refer to the descaler
instructions for the scale of water and descaler.)
2. Place the carafe onto the plate.
3. Plug in the appliance and then touch .
4. After descaling, rinse out the appliance by operating the appliance using water at
least twice (two full tanks of water).
TROUBLESHOOTING
SPECIFICATIONS
Ratings: 220-240V~ 50-60Hz 900W
Problem Possible Cause Solution
The carafe is leaking. The carafe is not inserted properly.
Make sure the center of the jug
aligns with opening of the
funnel.
The coee drops too slowly
or overows from the edge of
the removable funnel.
Coee grounds is too ne.
The lter is too dirty.
Use coarser coee powder.
Rinse the lter with water.
There is coee residue in the
carafe.
The lter is blocked. Clean the lter.
Water leaks from the bottom
of the coee maker.
There is leftover water in the
machine.
Do not use the coee mak-
er again, contact customer
service.
The coee maker is not
working.
The coee maker heats in an
abnormal state, which causes
the safety protective system to
activate.
The machine lacks water.
The coee maker should be
able to work after keeping it
still for 30 seconds, otherwise
contact customer service.
Fill the machine with enough
water.