Electrolux EL4300 - Basic Software Functionality; Motor Power Regulation and LED-Functionality

EN Publication number
Nr
Rev. xx Month/year PR - 23/37
23
3.2 Display Layout for models with Aeropro passive remote system:
3.2.1 Basic Software functionality
- Double ON/OFF switches, remote and body
- Soft-start
- Automatic 50/60Hz detection.
-
When started from unplugged, cleaner starts in power level 5, otherwise in last used mode.
- 5 manual power steps.
- (+) increases power level up to power level 5.
- (-) decreases power level down to power level 1.
- Power indication by segment LED, 1-5.
- Failure indication.
3.2.2 Motor power regulation and LED-functionality
1. Main plug connected:
- Motor is off.
- Segment LED:s indicates standby indicating “0”
2. First start by either of the two On/Off switches (after main plug is connected):
- Motor power starts, power level “5”.
- Segment LED indicates actual power.
3. (+) button is pressed:
- Power steps up.
- Segment LED indicates actual power.
4. (-) button is pressed:
- Power steps down.
- Segment LED indicates actual power.
5. Cleaner is turned off:
- Actual power setting is remembered by that microcontroller.
- Motor turns off.
- Segment LED shows standby by indicating “0”
6. Cleaner is turned on after being in standby mode:
- Cleaner turns on and goes into last power setting used.