EN Publication number
Nr
Rev. xx Month/year PR - 24/37
24
3.3 Display Layout for models with Aeropro active remote system:
3.3.1 Basic Software functionality
- Double ON/OFF switches, remote and body
- Soft-start
- Automatic 50/60Hz detection.
-
When started from unplugged, cleaner starts in power level 5, otherwise in last used mode.
- 5 manual power steps.
- (+) increases power level up to power level 5.
- (-) decreases power level down to power level 1.
- Power indication by segment LED, 1-5.
- Failure indication.
3.3.2 Motor power regulation and LED-functionality
1. Main plug connected:
- Motor is off.
- Segment LED:s indicates standby indicating “0”
2. First start by either of the two On/Off switches (after main plug is connected):
- Motor power starts, power level “5”.
- Segment LED indicates actual power.
3. (+) button is pressed:
- Power steps up.
- Segment LED indicates actual power.
4. (+) button is pressed, and kept pressed:
- Power steps up automatically until power level 5 is reached.
- Segment LED indicates actual power.
5. (-) button is pressed:
- Power steps down.
- Segment LED indicates actual power.
6. (-) button is pressed, and kept pressed:
- Power steps down automatically until power level 1 is reached.
- Segment LED indicates actual power.
7. Cleaner is turned off:
- Actual power setting is remembered by that microcontroller.
- Motor turns off.
- Segment LED shows standby by indicating “0”
8. Cleaner is turned on after being in standby mode:
- Cleaner turns on and goes into last power setting used.
3.3.3 Brush motor functionality
It is not possible to start the brush motor when the vacuum cleaner motor is turned off. If the cleaner
is turned off by one of the On/Off switches, the brush motor also turns off.
To Next Page
Loading...
Need help?
General
