EN Publication number
Nr
Rev. xx Month/year PR - 37/37
37
Cleaner with radio remote:
- Investigate if the LED on the remote indicates transmission. If not, change
battery and try again.
- If still no LED indication on remote, change remote control and reprogram
the cleaner according to above instruction.
- If LED indicates transmission, try replacing the remote according to above
instruction. If cleaner starts, replace the RF remote control.
- If still no function, replace the control unit in the cleaner. Be aware of the
position of the radio antenna. If replacing the control unit this has to learn
the RF-remote address according to above description, chapter 3.7.
Cleaner with active motor nozzle:
- Check the bent end, test with another HBTN. If possible to change power
setting, change.
- Check wiring from hose connection to 2G active PCB.
- Change 2G active PCB, test.
- Check wiring between 2G active PCB and control unit for failure or bad
connection.
- Change the control unit.
If the power regulation works for the first minutes after start, and then stops
working. Motor seems to run only in maximum speed.
- Check the cooling system to the Power module (tube, cooling house, tube
connection to dust compartment).
- Change the Power module PCB.
Nozzle motor doesn’t
start or
stop on active system
- Check the bent end, test with another HBTN. If possible to start nozzle
motor, change.
- Check wiring from hose connection to 2G active PCB.
- Change 2G active PCB, test.
- Check wiring between 2G active PCB and control unit for failure or bad
connection.
- Change the control unit.
LED’s on nozzle
doesn’t light,
but nozzle motor is
running
- Change nozzle electronic
To Previous Page
Loading...
