Electrolux ELI3CG - Alarms

25
Anomaly Type of
anomaly
Possible causes Actions
Stains on the glasses. Loss of
performance.
Foamy detergent present in the
wash tank.
Only use “non-foaming“ products for
professional dishwashers.
The dosing of rinse aid is not
correct.
Call detergent and rinse aid service
centre.
the hardness of the water is too
high or too low.
Adjust the amount of detergent and
rinse aid.
Call detergent and rinse aid service
centre.
Excessive foam in the tank. Loss
performance.
Residuals of food or detergent,
used for manual prewash, remains
in the dishes.
Remove residuals of food or detergent
from the dishes.
Wash water temperature is too low. Check if the water temperature of the
wash module is between 55℃ - 65℃.
Call detergent and rinse aid service
centre to set the temperature in
according to the detergent
specifications.
Foamy detergent present in the
wash tank.
Empty and refill the tank with water
until the foam has been removed.
Smears or spots on the
glasses.
Too much rinse-aid. Reduce the amount of rinse-aid.
Call detergent and rinse aid service
centre.
Low pressure from wash arms. Loss of
performance
The tank filter is clogged.
The wash pump filter is clogged.
The water drainage hose is
clogged.
The wash pump does not work
properly.
Clean the tank filter.
Clean the wash pump filter.
Call service centre.
Call service centre.
Low pressure from rinse arms. Loss of
performance
The rinse arms are clogged.
The water pressure after pressure
reducer is less than 1 bar.
Clean the rinse arms.
Call service centre.
The wash pump does not
work.
Blocking The wash pump is clogged. Call service centre.
The drain pump does not
work.
Loss of
performance
The drain pump is clogged. Call service centre.
The dishwasher is switched
off, but the appliance contin-
ues to fill water.
Loss of
performance
Inlet valve is damaged. Close the water supply tap or taps and
call service centre.
The display shows to close
the door.
Once closed the door, the dis-
play shows the same anomaly.
Blocking The magnetic switch door does
not work.
Call service centre.
If the fault persists after carrying out the above checks,
contact the Customer Care Service, remembering to
specify:
A. the type of fault;
B. the appliance PNC (product number code);
C. the Ser. No. (appliance serial number).
IMPORTANT
The appliance PNC and serial number are essential
for identifying the type of appliance and date of
manufacture.
NOTE!
For detailed information about the troubleshooting
see the complete user manual in the web site.
M.2 Alarms
Anomaly Type of anomaly Possible causes Actions
A1 NO WATER The tap is close.
The water inlet filter is clogged.
Too low pressure in hydraulic circuit.
Overflow not inserted (only for applian-
ces without drain pump).
Open the tap.
Clean the water inlet filter.
Check the minimum mains pressure.
Insert properly the overflow.
B1 INEFFICIENT
DRAINAGE
Overflow not removed.
The waste outlet pipe and/or the overflow
aperture obstructed.
Remove the overflow.
Remove any obstruction from the waste
outlet pipe and/or the overflow aperture.