27
REPLACING AN OVEN LIGHT BULB
Isolate the appliance from the electricity
supply before replacing the bulb.
The type of bulb required is a 300°C, 25 watt small
Edison Screw.
1. Make sure the appliance is cool before you
replace a bulb
2. Open the oven door and remove the shelves and
wirework runners.
Instructions on how to remove the wirework
runners are given on page 26.
3. Pull the glass bulb cover towards you and then
pull it off. If necessary use a screwdriver to
carefully lever off the cover, taking care not to
damage the oven cavity.
4. Unscrew the bulb by turning it to the left.
5. Fit a new bulb and then replace the glass bulb
cover.
6. Refit the wirework runners and replace the oven
shelves.
7. Restore the appliance to the electricity supply and
reset the time of day.
To Next Page
Loading...
