Electrolux EQBL100AS - Maintenance; Troubleshooting

electrolux integrated barbecue cleaning and care/maintenance/troubleshooting 11
Maintenance
Troubleshooting
problem possible cause remedy
Barbecuewon’t
light
No gas Check isolation valve
is ON
Gas bottle empty – refill
or change gas bottle
Ignition system
not working
Check battery – should
hear a clicking noise
when the knob is
depressed
Replace battery
Manually light the
barbecue
Ignition electrode
wet or dirty
Gently clean and dry
electrode ensuring
position is correct
Excess smoke
being emitted
from the cooking
area
Gas valve set too
high
Turn gas valves down or
turn off selected burners
Smell of gas
DO NOT
ATTEMPT TO
LIGHT THE
APPLIANCE
Gas leak Turn off gas at the
isolation valves
Check for leaks, tighten
joints
If problem persists call
Electrolux Service
The ignition system
To change the battery rotate the cover anti-clockwise to
release. Lift off the cover to access spring and battery. Lift
out the spring and battery. Replace with a new AA battery
and replace the cover. Test by depressing the knob and an
audible ‘clicking’ sound should be heard.
NOTE
Ensure that the battery has been placed in the correct
orientation.
Air vents
The mounting enclosure air vents should be checked prior
to each use, to ensure they are clear of any obstructions
that may affect the free flow of air.
Stainless steel burners
Burnersshouldbecheckedatleastonceperyearand
cleaned as necessary. Inspect burners to ensure no
residues have been deposited and gas ports are clear.
Cleaning the Oil Reservoirs
The Integrated barbecue has a unique oil management
system which uses overlapping channels to drain all oil
to the front into easily removed reservoirs and should be
cleaned after each use.
• Toremovereservoirs,pullupwardsfromthefrontofthe
barbecue and dispose of the contents of the catchment
responsibly. Rinse oil reservoirs in warm soapy water.
The reservoirs can be placed in the dishwasher if
desired.
tips and information
Special note on “tea staining”
Sometimes stainless steel surfaces are affected by a brown
discolouration called tea staining. This usually occurs in
areas which use high heat and can be easily removed using
specialised stainless steel cleaners. For best results, we
recommend that specialised cleaners be used regularly on
all stainless steel components. You will find these cleaners
at most hardware stores.
tips and information
Special note on stainless steel
The stainless steel panels may distort while in use but will
return to normal when cold.