16
The power plug mu st be accessible
after installation of the cabinet.
Door Reversal
1. C lose the cabinet an d remove the
plug from the electrical socket.
2. Remove the ventilation grille. There
is a part on the grille that can be
removed. Remove and reposition it on
the other side.
3. Put the cabinet on a wooden board
when it is laid down. Later, when
raising the cabinet, it will be easier to
grip under the cabinet thanks to the
boar d.
1
2
3
4. On the u pper part of the cabinet.
Put the hinge pin on the other side.
On the lower part of the cabinet.
Unscrew the hinge. Move the hinge
pin and plastic cover. Secure the h in ge
on the other side.
4
Removeanyplayinthedoorby
adjusting the height of the lower hinge
with the supplied spanner. Secure with
the lock-nut.
Raise the cabinet an d replace the
ventilation grille.
5. Move the handle.
Unscrew the handle and secure it to
the other side. Press the supplied
plastic plugs into the holes to which
the h an dle was previously fitted.
5
Put the cabinet in position. Check that
the appliance is level. See the section
"Positioning the cabinet".
Downloaded from www.vandenborre.be
To Next Page
Loading...
