7
USE
Position and clean the cabinet as
explained in the section "Installation".
Check that the drain hose at the rear
of the cabinet discharges into the drip
tray.
Before inserting the power plug into the outlet and switching on the cabinet for
the first time, leave it standing upright for about 2 hours. Otherwise the
compressor may sustain damage. This time will allow the oil sufficient time to
return to the compressor.
Control P an el
12
A
B
C
D
EF
A. Wine cooler power switch
Switch es the wine cooler on and off.
B. Temperatu re display
Shows the average temperatu re in the
middle of the wine cooler.
C. Temperature adjustment
buttons/thermostat
Used to set the temperature.
D. Lighting
E. Alarm shut-off button
Used to turn the audible alarm off.
F. Red warning lamp
Flashes when the alarm in the cabinet
has been triggered.
To start the wine cooler and set the correct temperature
Switching on:
Switch on the wine cooler by pressing
the power switch.
12
Setting the temperature
Press the buttons until the desired
temperature flashes in the temperature
display (The temperatur e can be set
between +6°C an d +15°C.)
"+" raises the temperature.
"-" lowers the temperature.
12
Once set, the temperature display
shows the cu rrent temperature inside
the cabinet.
Downloaded from www.vandenborre.be
To Next Page
Loading...
