Electrolux ESF 472 - Water Outlet Connection

Water Outlet Connection
The end of the drain hose can be connected as
follows:
= to the sink outlet siphon, securing it if necessary
with a clip;
= to a wall outlet provided with vent-hole, minimum
internal diameter 4 cm,
= hooked over the edge of the sink using the special
curved plastic guide provided.
The waste connection must be at a height of between
30 cm (minimum) and 100 cm (maximum) from the
floor.
It makes no difference which way the drain hose
faces either to the right or left of the dishwasher.
Avoid bending or kinking the hose as this could
prevent or slow down the discharge of water.
If you use a drain hose extension it must be no longer
than 2 metres and its internal diameter must be no
smaller than the diameter of the hose provided.
Likewise the internal diameter of the couplings used
for connection to the waste outlet must be no smaller
than the diameter of the drain hose.
Note:
The
sink
plug
must
not
be
in
place
when
the
machine
is
draining
as
this
could
cause
the
water
to
siphon
back
into
the
machine.
mi
=,
max 100 cm
min 30 cm
max 100 cm i
REREEINRARA
<C}
GMMASEIELESSILSEDIELTILELITLELSESLSLESSES EDL SELLSSEPSSISLL PASS ISSISSOIT ESOS LEIS STI LOG)
28