DO NOT use connection hoses
which have previously been used for
an old appliance.
This appliance has been fitted with
safety features which will prevent
the water used in the appliance from
returning back into the drinking wa-
ter system. This appliance complies
with the applicable plumbing regu-
lations.
Water outlet hose connection
The end of the drain hose can be con-
nected in the following ways:
1. To the sink outlet spigot, securing it
to the underside of the work surface.
This will prevent waste water from
the sink running into the machine.
2. To a stand pipe provided with vent-
hole, minimum internal diameter 4
cm.
The waste connection must be at a
height of between 30 cm (minimum) and
100 cm (maximum) from the bottom of
the dishwasher.
The drain hose can face either to the
right or left of the dishwasher.
Ensure the hose is not bent or squashed
as this could prevent or slow down the
discharge of water.
The sink plug must not be in place when
the machine is draining as this could
cause the water to syphon back into the
machine.
If you use a drain hose extension it must
be no longer than 2 metres and its inter-
nal diameter must be no smaller than the
diameter of the hose provided.
Likewise the internal diameter of the
couplings used for connections to the
waste outlet must be no smaller than the
diameter of the hose provided.
When connecting the drain hose to an
under sink trap spigot, the entire plas-
tic membrane (A) must be removed.
Failure to remove all the membrane will
result in food particles building up over
time eventually blocking the dishwasher
drain hose spigot.
34 electrolux installation
To Next Page
Loading...
