Electrolux EVE615DSE - Setting up Your Oven’s Accessories Continued

Standard side racks
Pyro-proof side racks
(EVEP616DSE only)
• Insert the rear peg in the
rear access hole ensuring
the peg is fully inserted.
• Then, insert the front peg
into the front access hole
and push in firmly.
• Insert the rear peg in the
rear access hole ensuring
the peg is fully inserted.
• Then, locate the front screw
hole and insert the screw.
• Tighten with the Allen key.
Fit oven shelves
• Locate detents on the side wires
of the shelf as indicated in the
diagram to the right.
• Align shelves evenly on both oven
sides and slide shelf between
guide rails.
• Ensure the shelf is fully inserted,
does not interfere with oven door
closure.
Fit the shelf/tray to the
telescopic slides
• Push the shelf or tray along
the top of the telescopic
slide to the back post, as
shown in the diagram to
the right.
• Drop the front of the shelf or
tray onto the telescopic slide
ensuring it sits behind the
front post, as shown in the
diagram to the right.
• When fully inserted, the shelf
or tray should not obstruct
the closed oven door.
Front postBack postShelf Shelf
OR
Setting up your oven’s accessories Continued
Fix the side racks:
Standard and Pyro-proof side racks are installed differently. Please refer to the instructions which are
relevant to your oven model below.
Setting up your oven’s accessories Continued
Detent