To avoid breakage: Do NOT handle or manipulate
the unit by the cooktop.
The counter-top around the cut-out should be flat and leveled (see
hatched area on illustration 1).
Before installing the unit, measure the heights of the two (2) cabinet
sides (H1-4), front and back (see illustration 1) from the floor to the top
of the counter.
Level the range using the Shave 11/2"Max. 1
two (2) front leveling legs Raised (3.8cmMax.)
I
and the two (2) adjustable Edge
leveling wheel, so that the to Clear
height from the floor to Space for
the underside of the metal 311/2" (81cm)
flange is greater than the Wide Cooktop.
tallest cabinet measurement
by at least 1/16" (see
illustration 2).
Remove and discard the two rear leveling legs, they are only in place to
solidify the unit for the transport.
Slide the unit into the cabinet. Make sure the center of the unit is alignedwith the center of the cabinet cut-out.
Illustration 1
Remove the protective channels on each side of the cooktop (if provided).
The metal flange under each side of the cooktop MUST be placed over
the cabinet countertop for proper unit support. The cooktop should
NOT rest directly on the countertop (see illustration 2) or else it could
cause damage to the cooktop voiding the warranty. Level the unit if
needed.
After the installation, MAKE SUREthat the unit is
supported by the two front leveling legs and the
two adjustable leveling wheels and NOT by the
cooktop.
successfully
install the
range, the initial
level height
from floor to
underside of
cooktop frame
should be at
least 1/16"
taller than
sides
as measured in
step 2.
Illustration 2
3
To Next Page
Loading...
