11. How to change an option or a
programme during its cycle
It is possible to change any option before the
programme carries it out.
Before you make any change, you must pause the
machine by pressing the “Start/Pause” button.
Changing a running programme is possible only by
resetting it.
Turn the programme selector dial to “Off” and then
to the new programme position.
Start the new programme by depressing the
“Start/Pause” button.
The machine will resume the cycle from the
beginning and the washing water in the tub will not
be emptied out.
12. How to interrupt a programme
during its cycle
Depress the “Start/Pause” button to interrupt a
programme which is running, the corresponding light
starts to flash. Depress the button again to restart
the programme.
13. How to open a programme
during its cycle
First set the machine to PAUSE by pressing the
“Start/Pause” button.
If the door does not open, this means that the
machine is already heating, that the water level is
above the bottom edge of the door or that the drum
is turning.
If you cannot open the door but you need to open it
you have to switch the machine off by turning the
programme selector dial to “Off” position.
After about 3 minutes the door can be opened.
Pay attention to the level and temperature of the
water in the machine !
After closing the door, turn the programme selector
dial to the programme previously selected and start it
by depressing the “Start/Pause” button.
14. At the end of the programme
At the end of the programme, the washer-dryer stops
automatically.
The light of the “Start/Pause” button goes off, the
phase indicator lights go off. The display will show a
flashing zero.
If the (Rinse Hold) option has been selelcted, the
corresponding light will be on, the display will show a
flashing zero but the door will be locked to indicate
that the water must be drained.
To complete the cycle, there are 2 possibilities :
• turn the selector dial to the “Off” position, select
programme “Drain” and then depress the
“Start/Pause” button: the water is emptied out
without spinning.
or
• turn the selector dial to the “Off” position and
then select programme “Spin” or “Delicate
Spin”. Select the spin speed by means of the
relevant button and then depress the
“Start/Pause” button. The water is emptied out
and the laundry is spun at the selected spin
speed.
• turn the selector dial to the “Off” position to
switch the machine off.
Remove the laundry from the drum and carefully
check that the drum is empty so as to avoid any
forgotten items being damaged in a subsequent
wash (e.g. shrinking) or their colour running into a
load of whites.
If you do not intend to carry out another wash, close
the water tap.
Leave the door open to prevent the formation of
mildew and unpleasant smells.
20
To Next Page
Loading...
