ENGLISH
17
4. Switch the machine ON and OFF
Turn the selector dial to the desired programme to
switch the appliance on.
To switch the appliance off turn it to «O».
Switching the appliance for the first time.
LANGUAGE
When switching on the appliance for the first time
you must set the language in which you want the
indicators in the display to appear.
Important!
If the display is not showing any language, the
appliance has already been switched on once. In
such case, go to the chapter «Change language» if
you would like to change the language setting.
Example:
1.Press the «Change» button until the desired
language appears in the display.
2.Press the EXIT button to confirm the selection.
All indicators in the display will appear in this
language from now on.
When the appliance is switched on again all
indicators in the display will appear in this language.
Note:
If the undesired language has been set, press
contemporary SPIN + OPTIONS buttons for about 2
seconds in order to change the language.
Follow the instructions as before.
Operating sequence
Before washing your first load of laundry, we
recommend that you run a cotton cycle at 60°C,
with the machine empty, in order to remove any
manufacturing residue from the drum and tub.
Pour half a measure of detergent into the main wash
compartment and start up the machine.
1. Place the laundry in the drum
Open the door.
Place the laundry in the drum, one item at a time,
shaking them out as much as possible.
Close the door.
2. Measure out the detergent
Pull out the dispenser drawer until it stops. Measure
out the amount of detergent recommended by the
manufacturer in a graduated cup and pour it into the
main wash compartment .
If you have selected the prewash function, pour
detergent into the appropriate compartment marked
.
3. Measure out the additive
If required, pour fabric softener into the compartment
marked , without exceeding the «MAX» mark.
To Next Page
Loading...
