Technical Support - A.D.L. 13/70 599 74 23-12 Rev.00
4.2 Reading the alarms
The last three alarms stored in the FLASH memory of the circuit board can be displayed:
• Enter the diagnostic mode.
• Irrespective of the type of circuit board and configuration, turn the programme
selector knob clockwise to the eleventh position and this will display the last
alarm.
• To display previous alarms, press the button to the left of the START/PAUSE
button in sequence (as shown in the figure)
• To return to the last alarm, press the START/PAUSE button.
To Next Page
Loading...
