Electrolux EWW12842 - Page 30

30 www.electrolux.com
To clean the water inlet filters:
1.
Close the water tap.
2.
Remove the water inlet hose from
the water tap.
3.
Clean the filter in the inlet hose
with a stiff brush.
4.
Remove the inlet hose behind
the appliance.
5.
Clean the filter in the valve with
a stiff brush or a towel.
6. Install again the inlet hose.
Make sure that the couplings are
tight to prevent leakages.
7. Open the water tap.
If the machine is exposed to
temperatures below 0°C, certain
precautions should be taken.
10.9 The Dangers Of Freezing
Turn off the water tap.1.
2. Unscrew the inlet hose.
3. Remove the drain hose from the
rear support and unhook it from
sink or spigot.
4. Pull forward the drainage duct
and that of the inlet hose in a
bowl placed on the floor and let
water drain out.
5. Screw the water inlet hose back
on and reposition the drain hose
and drainage duct.
When you intend to start the
machine up again, make sure that
the room temperature is above 0°C.
Disconnect the mains plug
from the mains socket.
45°