ENGLISH 29
6. Pull back the drainage duct and
turn the filter to remove it.
7. Remove fluff and objects from
the pump (if there are any).
8. Make sure that the impeller of the
pump can turn. If this does not
occur, contact the service centre.
9. Clean the filter under the water tap.
1
2
If your water is very hard or
contains traces of lime deposit, the
water inlet filter may become
clogged.
It is therefore a good idea to clean
it from time to time.
10.8 Cleaning The Water Inlet Filter
10. Put the filter back in the pump into
the special guides. Make sure that
you tighten correctly the filter to
prevent leakages.
11. Put the flap back and close the
drain pump door.
To Next Page