ENGLISH 35
INSTALLATION13 .
Never place cardboard, wood or
similar materials under the machine
to compensate for any unevenness
in the floor.
Loosen or tighten the feet to adjust
the level. A correct adjustment of
the appliance level prevents the
vibration, noise and the movement
of the appliance when in operation.
When the machine is levelled, try
to rock it from corner to corner. If it
does rock, adjust the legs again
until it is levelled and does not
rock.
13.1 Positioning
Use a spirit level on the top and
side of the machine to check the
levels.
If you do not have a spirit level, as a
guide use the edge of a door frame,
cupboard or bench to check that
the machine is level.
It is important that your
machine stands firm and level
on the floor to ensure correct
operation.
That the appliance must not be
installed behind a lockable door, a
sliding door or a door with a hinge
on the opposite side to that of the
machine door is restricted.
Connect the water inlet hose to a
tap with 3/4” BSP thread.
Use the hose supplied with the
machine. DO NOT USE OLD
HOSES.
The other end of the inlet hose
which connects to the machine
can be turned in any direction.
Simply loosen the fitting, rotate
the hose and retighten the fitting,
making sure there are no water
leaks.
13.2 Water Inlet
Install the machine on a flat hard
floor. Make sure that air circulation
around the machine is not
impeded by carpets, rugs etc.
Check that the machine does not
touch the wall or cupboard units.
To Next Page
Loading...
