8VHU
0D[P
5HPRWHFRQWURO
3RUWDEOH$&
TURNING THE UNIT ON
Remove the cover at the back of the
remote control.
Insert the provided batteries correctly
(see the instructions inside the battery
compartment).
Close up the cover.
To replace the old batteries (which have
been used up) with two new R03P “AAA”
1.5V batteries, repeat the steps above.
Battery Installation and Important
Instructions
How to Use the Remote Control
7.2
Remote Control
1
2
5
3
7
4
8
6
Remote Control screen
Temp/Timer setting button
On/O button
Mode button
Sleep button
Timer button
Swing button
Speed button
If the remote control unit is replaced or
discarded, the batteries must be removed
and disposed of in accordance with
local legislation as they do harm to the
environment.
Do not mix old and new batteries.
Do not mix alkaline, standard (carbon-
zinc) or rechargeable (nickel-cadmium)
batteries.
Do not dispose of batteries in re. Batteries
may explode or leak. If the remote control
is not used for a long time, remove the
batteries from the remote control.
The remote control must be handled with
extreme care. Do not drop it or expose it
to direct sunlight or sources of heat.
This device complies with Part 15 of the
FCC Rules. Operation is subject to the
following two conditions:
(1) This device may not cause harmful
interference, and (2) this device must
accept any interference received,
including interference that may cause
undesired operation.
Point the remote control at the location
of the signal receiver. The remote control
must be no more than 16 ft (5 meters)
away from the unit (without obstacles
between the remote control and the unit).
To Next Page
Loading...
Need help?
General
Weight and Dimensions
