10
Installation Instructions
1. Locate the anti-siphon ring shipped with your
washer. Place it over the end of the drain hose and
slide it past the fi rst ring of “accordion” ribs.
2. Form a “U” shape on the end of the drain hose with
the hose pointed toward the drain. Place the formed
end in a laundry tub or a standpipe and secure the
drain hose with the cable tie (provided in the enclo-
sure package) to the standpipe, inlet hose, laundry
tub, etc. so the hose does not pull out from the force
of the water.
Connecting drain and electrical
Grounding type
wa
ll receptacl
Po
wer cord with
3-prong
gr
ounded plug
Do not,
under
an
y cir
cumstances,
cut,
remo
ve
or b
ypass th
gr
ounding pr
ong.
IMPORTANT
Check to ensure the power is off at a circuit breaker/
fuse box before plugging the power cord into an outlet.
3. Plug the power cord into a grounded outlet.
4. Turn on the power at a circuit breaker/fuse box.
5. Carefully slide the washer to its fi nal position. Re-
check for level and rock corners for stability. Re-
move and discard door tape.
6. Read the Use & Care Guide provided with the
washer. It contains valuable and helpful information
that will save you time and money.
7. See the next page about performing a brief, helpful
“Installation Cycle” on your new washer.
8. If you have any questions during initial operation,
please review the “Service Prevention Checklist” in
your Use & Care Guide before calling for service.
9. Place these instructions in a location near the
washer for future reference.
NOTE
A wiring diagram and technical data sheet are located
under the washer top panel, on top of the detergent
dispenser housing.
CABLE TIE
ANTI-SIPHON
DISC
SLIDE DISC
TO HERE
To Next Page
Loading...
Need help?
General
