Electrolux Icon E23CS78HPS6 - Controls & Settings; Allowing Cooling Time before Use; Setting Cooling Temperatures

Controls & Settings
Allowing Cooling Time Before Use
To ensure reliable food storage, allow your refrigerator and freezer to operate with the doors closed for 8
to 12 hours before placing food inside. During this cooling period, you do not need to adjust the controls,
which are preset at the factory.
Setting Cooling Temperatures
Your refrigerator comes with a state-of-the-art electronic digital control system. The system's control panel
is located at the top of the fresh food compartment.
The two digital displays on the left half of the control panel indicate the current temperatures of your
freezer and fresh food compartments.
To adjust the temperature to a higher or lower setting, press the Up or Down Arrow button closest to the
display. The first time you press the button, the display shows the last setting you entered. Each press of
the button after that increments the setting by one degree.
The display shows your new setting momentarily, then
FREEZER [EMP FR_DGETEMP
DYNASti€ C )01Ht(
changes back to the current temperature.
Choosing Fahrenheit or Centigrade
Depending on which temperature standard you
prefer to use, you can set your control panel to
display in Fahrenheit or Centigrade. To change
between Fahrenheit and Centigrade, press the
Mode button (located between the two digital
temperature displays).
Making Temperature Adjustments
After running your refrigerator for 24 hours, you
can adjust temperatures as needed. Make your
adjustments small and gradual, allowing time for
temperatures to change and stabilize. Refer to the
following guidelines for temperature settings.
TemperatureCentrel Range
Freezer
Fahrenheit Centigrade Fahrenheit
Warmest 60 -,i4 _' 47_
Warmer
Fact0ry Setting Midpoint 00 -te_ 37_
Colder
Coldest -60 -21" 330
FreshFeed
Centigrade
80
iQ
TemperatureAdjustment
Adjust FreshFoodcontrol one degree
If FreshFoodcompartmentis too warm colder bypressing Down (Colde r)
button.
If FreshFoodcompartment istoo cold Adjust FreshFoodcontrol one degree
warmerby pressingthe Up (Cold) button.
It Freezerc0m.-artmentis t00 walm Adjust FreezerC0ntr010nedegreec01der
by pressing Down (Colder) button.
If Freezercompartmentis too cold
Adjust Freezercontrol one degreewarmer
by pressingthe Up (Cold) button.