Guide to diagnostics of EWX11831 electronic controls
2013 TS/DT-mdm FCPD-dp
18/71
599 77 00-82 Rev. 01
4.6 Notes on the behaviour of certain alarms
Configuration alarm E93: when this alarm rings (when turned on) the machine blocks and the alarm code appears on the display, provided the relevant
configuration part is intact.
It is not possible to access diagnostics mode and the only available option is to turn the appliance off.
Configuration alarm E94: and the code can be viewed from the display.
The diagnostics mode cannot be accessed and the “quick alarm viewing” mode cannot be used.
Alarms EH1-EH2-EH3: in the event of problems with the supply voltage, the appliance remains in alarm status until the mains frequency or voltage returns to
acceptable values or the appliance is switched off (ON/OFF button). Only the “H” alarm family is displayed if the problem occurs while the appliance is
working normally, the code is shown simultaneously on the display.
The diagnostics mode cannot be accessed and the “quick alarm viewing” mode cannot be used: the alarm can only be read in full when the situation has
normalised.
To Next Page
Loading...
Need help?
General
