Step 7 Clean the glass panel with
water and soap. Dry the
glass panel carefully. Do
not clean the glass panels
in the dishwasher.
Step 8 After cleaning, do the
above steps in the oppo‐
site sequence.
Step 9 Install the smaller panel first, then the larger and the door.
Make sure that the glasses are inserted in the correct position otherwise
the surface of the door may overheat.
11.6 How to replace: Lamp
WARNING!
Risk of electric shock.
The lamp can be hot.
Before you replace the lamp:
Step 1 Step 2 Step 3
Turn off the oven. Wait un‐
til the oven is cold.
Disconnect the oven from
the mains.
Put a cloth on the bottom
of the cavity.
Top lamp
Step 1 Turn the glass cover to remove
it.
Step 2 Clean the glass cover.
Step 3 Replace the lamp with a suitable 300 °C heat-resistant lamp.
Step 4 Install the glass cover.
12. TROUBLESHOOTING
WARNING!
Refer to Safety chapters.
12.1 What to do if...
In any cases not included in this table
please contact with an Authorised
Service Centre.
Problem Check if...
The oven does not
heat up.
The fuse is blown.
www.electrolux.com36
To Next Page
Loading...
