Instruction Manual LX1700
Before use, please read all the instructions carefully and retain for future reference.
Steam Ironing
1. To begin steam ironing, turn the steam knob on to , then ll the tank with water
using the water cup. Prevent water overow by keeping iron erect when lling and by not
exceeding the MAX line. It is best to use distilled water.
o position
max position
2. Put the plug into the outlet and adjust the temperature regulator to a suitable temperature
according to the fabric.
3. Wait until the lights turn o, push the steam knob, and then you may begin ironing.
4. Pay attention to the water in the water tank. When the water is almost running out you
must unplug the iron and rell the tank.
5. After you nish ironing, unplug the iron immediately. Turn the steam knob to setting,
empty the water tank and place the iron in an upright position.
6. Put the plug into the outlet again and power on for 5 minutes so that any remaining
water should evaporate. Power o and store away properly.
Steam Jet Function
• Turn o the steam knob rst.
• Turn the temperature regulator to MAX position (otherwise you may see water leakage).
• After the indicator goes o, press the steam jet button.
• Press the button once every second for a steam release.
Water Spray
• Ensure that the water tank has enough water in it.
• Push the water spray button four times to make the clothes wet. Spray function is used
for ironing thick cotton or hemp fabric.
• Water spray can remove wrinkles.
Auto Shut-o Feature
• The red light will be on while the iron is heating.
• Once iron is heated, the light will turn o.
• When the iron is in a horizontal position, it will power o automatically after 30 seconds
.
• When the iron is in a vertical position, it will power o automatically after 8 minutes