Electrolux SPEEDELIGHT - FLEX (models equipped only); PROGRAM SETTING Multiphase

27
FLEX (models equipped only)
The Flex use allows you to cook food without being
crushed by the upper plate. With this option, it is possible to
adjust the Flex if the parameter is activated (models
equipped only).
16 (models equipped only) 17
18 FLEX
19 FLEX INSTRUCTIONS
With Flex ON the upper plate returns to the initial position
at the end of the cooking cycle (models equipped only).
NOTE!
If necessary it is possible to lower the upper
plate; press simultaneously the buttons “1“ and
“8“ with the appliance only ready for cooking and
displaying the following screen.
PROGRAM SETTING Multiphase
1 2
3
NOTE!
It is possible to
activate the Mul-
Phase if the
parameter is
enabled.
PROGRAM SETTING Multiphase (cont'd.)
4 5
6 7
For the next steps, please
refer to points 17 – 18 of
PROGRAM SETTING -
Single Phase table.
8
9 10 PLATE HEATING TIME
For the next steps, please
refer to points 5 – 6 – 7 of
PROGRAM SETTING -
Single Phase table.
11 ADD PHASE
12 MICROWAVE (Mw)
OFF-ON
13
Mw
Mw
OFF
ON OFF
OFF
OFF
ON
OFF
ON
FLEX
FLEX
3x
ON OFF
C
Phase_1_Heathing 1:15
Phase_2_Microw 0:45
SET
Flex On
OFF
OFF
Mw
OFF
Mw
OFF
ON OFF
Mw Mw