Cleaning the door seal
Wipe the door seal with a damp cloth immediately
after the drying cycle has finished.
Emptying the water reservoir
Empty the water reservoir after every drying cycle.
If the water reservoir is full, an active programme
is stopped and the Water reservoir (Behälter) diode
is on. To continue the programme, empty the wa-
ter reservoir.
Warning! The condensed water cannot be
use to drink or to prepare a food.
1.
Take out water reservoir completely.
2.
Pour condensed water out into a basin or sim-
ilar receptacle.
3. Refit water reservoir.
If the programme has been interrupted as a re-
sult of the water reservoir being full: Press the
Start / Pause button to continue the drying cy-
cle.
The water reservoir has a volume of approx.
4 litres. This is sufficient for around 7 kg of
laundry which has previously been spun at 1000
revolutions/ minute.
The condensed water can be used as distil-
led water, e.g. for steam ironing. However
first filter the condensed water (e.g. with a coffee
filter) to remove any residue and small pieces of
fluff.
Cleaning heat exchanger
If the Condenser (Wärmetauscher) diode is on, the
heat exchanger needs to be cleaned.
Caution! Operating when the heat
exchanger is blocked with fluff can damage
the dryer. This also increases energy consumption.
1. Open door.
2.
Open door in plinth. To do this, press the re-
lease button on the bottom of the door aper-
ture and open the door in the plinth to the left.
3. Clean fluff from the inside of the door and the
heat exchanger front chamber. Wipe the door
seal with a damp cloth.
4.
Turn both lock washers inwards.
5.
Use the handle to pull the heat exchanger out
of the base and carry it horizontally to prevent
any remaining water from spilling.
electrolux 69
To Next Page
Loading...
