6. To empty the heat exchanger, hold vertically
over a washing-up bowl.
Caution! Do not use sharp objects to clean.
The heat exchanger could develop leaks.
7. Clean heat exchanger.
It is best to use a brush or to rinse thoroughly
with a hand-held shower.
8. Replace heat exchanger and lock into place
(turn both lock washers outwards until they
snap into place).
9. Close door in plinth.
Caution! Never operate the dryer without
the heat exchanger.
Cleaning the drum
Caution! Do not use abrasives or steel wool
to clean the drum.
Lime in the water or cleaning agents may
form a barely visible lining on the inside of the
drum. The degree to which the laundry has been
dried is then no longer detected reliably. The laun-
dry is damper than expected when removed from
the dryer.
Use a standard domestic cleaner (e.g. vinegar-
based cleaner) to wipe down the inside of the drum
and drum ribs.
Clean operating screen and housing
Caution! Do not use furniture cleaners or
aggressive cleaning agents to clean the
machine.
Use a damp cloth to wipe down the operating
screen and housing.
What to do if ...
Troubleshooting by yourself
Problem
1)
Possible cause Remedy
Dryer does
not work.
Dryer not connected to mains supply.
Plug in at mains socket. Check fuse in
fuse box (domestic installation).
Loading door opened. Close loading door
The Start / Pause button not pressed. Press the Start / Pause button.
Unsatisfactory
drying results.
Incorrect programme set.
Set suitable programme.
2)
Fluff filters clogged.
Clean fluff filters.
3)
Heat exchanger clogged.
Clean heat exchanger.
3)
Max. loading exceeded. Respect max. loading volume.
Covered ventilation grill. Uncover ventilation grill in base area.
Residue inside the drum. Clean the drum inside.
High water hardness.
Set suitable water hardness
4)
.
Loading door
does not close
Filters not locked in place.
Install fine filter and/or snap course filter
into place.
Err ( Error ) on
the LCD.
5)
Attempt to change parameters after start
of the programme.
Turn the dryer off and on. Set requested
parameters.
No drum light
Programme selector in Off (Aus) position.
Turn it to Drum light (Beleuchtung) (if
available) or to any programme.
Defective light bulb. Replace light bulb (see next section).
Abnormally
elapsing time
on the LCD
5)
Time to end is calculated on the basis of:
type, volume and dampness of laundry.
Automatic process; this is not a machine
fault.
Programme
inactive
Full water reservoir.
Empty water reservoir
3)
, press Start /
Pause button.
Drying cycle
to short
Small laundry volume./Too dry laundry for
selected programme.
Select time programme or higher drying
level (e.g. Extra dry (Extratrocken)).
Drying cycle
to long
6)
Fluff filters clogged. Clean fluff filters.
70 electrolux
To Next Page
Loading...
