Important!
• The selected delay can be changed only
after selecting the washing programme
again.
• The door will be locked throughout the
delay time. If you need to open the door,
you must first set the washing machine to
PAUSE by pressing the button 8 . After
you have closed the door, press the but-
ton 8 again.
The button 9 can not be selected with
DRAIN programme.
Select an additional rinse
This appliance is designed for saving water.
However, for people with a very delicate
skin (allergic to detergents) it may be nec-
essary to rinse the laundry using an extra
quantity of water (extra rinse).
Press simultaneously the buttons 2 and 3
for some seconds: the pilot light 10.2
comes on.
This function stays permanently on. To re-
move it press the same buttons again until
the pilot light 10.2 goes off.
Altering an option or a running
programme
It is possible to change any option before
the programme carries it out. Before you
make any change, you must pause the
washing machine by pressing the button 8 .
Changing a running programme is possible
only by resetting it . Turn the programme
selector dial to
and then to the new pro-
gramme position. Start the new programme
by depressing the button 8 again. The
washing water in the tub will be not emp-
tied out.
Interrupting a programme
Depress the button 8 to interrupt a pro-
gramme which is running, the correspond-
ing light starts blinking. Depress the button
again to restart the programme.
Cancelling a programme
Turn the selector dial to
to cancel a pro-
gramme which is running. Now you can se-
lect a new programme.
Opening the door after the programme
has started
First set the machine to pause by pressing
the button 8 .
• if the DOOR symbol disappears, the door
can be opened.
• if the DOOR symbol doesn’t go off, it
means that the machine is already heat-
ing, that the water level is above the bot-
tom edge of the door. In this case the
door cannot be opened.
• If you cannot open the door but you need
to open it, you have to switch the ma-
chine off by turning the selector dial to
. After some minutes the door can be
opened ( pay attention to the water
level and temperature! ).
After closing the door, it is necessary to se-
lect the programme and options again and
to press button 8 .
At the end of the programme
The machine stops automatically, the pilot
light of button 8 and the symbol 7.5 goes
off and a blinking
will appear on the dis-
play. Some acoustic signals sound. The
door can be opened.
If a programme or an option that ends with
water still in the tub has been selected, a
blinking
will appear on the display, the pi-
lot light of button 8 goes off and the door
remains locked to indicate that the water
must be emptied out before opening the
door.
Follow the below instructions to empty out
the water:
•
Turn the programme selector dial to
• Select the draining or spinning pro-
gramme
• Reduce the spin speed, if needed, by
pressing the relevant button
•Press button 8 to start the programme
• When the programme has finished the
display shows a blinking
. The symbol
7.5 goes off and the door can be
opened.
Turn the programme selector dial to
to
switch the machine off. Remove the laundry
from the drum and carefully check that the
drum is empty. If you do not intend to carry
out another wash, close the water tap.
Leave the door open to prevent the forma-
tion of mildew and unpleasant smells.
10 electrolux
To Next Page
Loading...
