Problem Possible cause/Solution
Spinning starts late or the machine does not
spin:
The electronic unbalance detection device has
cut in because the laundry is not evenly distrib-
uted in the drum. The laundry is redistributed by
reverse rotation of the drum. This may happen
several times before the unbalance disappears
and normal spinning can resume. If, after some
minutes, the laundry is still not evenly distributed
in the drum, the machine will not spin.
• The laundry load is perhaps to little, add more
items, redistribute the load manually and then
select the spinning programme.
The machine makes an unusual noise:
The machine is fitted with a type of motor which
makes an unusual noise compared with other
traditional motors. This new motor ensures a
softer start and more even distribution of the
laundry in the drum when spinning, as well as
increased stability of the machine.
No water is visible in the drum:
Machines based on modern technology operate
very economically using very little water without
affecting performance.
The display shows the alarm code :
Anti-flooding system has activated.
• Disconnect the appliance, close the water tap
and contact the Service Force Centre
If you are unable to identify or solve the
problem, contact our service centre. Before
telephoning, make a note of the model, se-
rial number and purchase date of your ma-
chine: the Service Centre will require this in-
formation.
TECHNICAL DATA
Dimensions Width
Height
Depth
Depth (Overall dimensions)
60 cm
85 cm
60 cm
63 cm
Electrical connection
Voltage - Overall power
- Fuse
Information on the electrical connection is given on the rating plate, on
the inner edge of the appliance door.
Water supply pressure Minimum
Maximum
0,05 MPa
0,8 MPa
Maximum Load Cotton 7 kg
electrolux 23
To Next Page
Loading...
