Electrolux WA GL6 E 101 - First Use and Daily Operation; Initial Setup and First Wash

FIRST USE
• Ensure that the electrical and water
connections comply with the installa-
tion instructions.
• Remove the polystyrene block and
any material from the drum.
• Pour 2 litres of water into the main
wash compartment
of the deter-
gent drawer in order to activate the
ECO valve. Then run a cotton cycle
at the highest temperature without
any laundry in the machine, to re-
move any manufacturing residue
from the drum and tub. Pour 1/2 a
measure of detergent into the main
wash compartment and start the
machine.
DAILY USE
Load the laundry
1. Open the door by carefully pulling the
door handle outwards. Place the laun-
dry in the drum, one item at a time,
shaking them out as much as possible.
2. Close firmly the door. You must hear a
click during closing.
Warning! Do not embed the laundry
between the door and the rubber joint.
Measure out the detergent and the
fabric softener
Your new appliance was designed to re-
duce water, energy and detergent con-
sumption.
Pull out the dispenser drawer until it stops.
Measure out the amount of detergent re-
quired, pour it into the main wash compart-
ment
and, if you wish to carry out the
prewash phase, pour the detergent into
the compartment marked
.
If you wish to perform the stain function,
pour the stain remover into the compart-
ment
marked with an arrow.
If required, pour fabric softener into the
compartment marked
(the amount used
must not exceed the MAX mark in the
drawer).
electrolux 7