1.5 Display Dimming:
The MVP provides two methods of controlling the brightness of the TFT display. When the “Brightness Control” is
set for “Auto Dimming,” the display will automatically dim as the ambient light reduces. The light sensor is located
next to the USB port on the MVP front panel.
When the “Brightness Control” is set for “External,” an external control pot can be used to control the brightness
of the MVP display. The Electronics International CP-1-MVP Intensity Control Pot can be used for this purpose.
Note: The MVP display will be at full intensity if the “Brightness Control” is set to “External” and there is no
external pot connected to the MVP.
The Brightness Control can be found on the “Display Controls” screen. To navigate to the “Display Controls”
screen start by viewing the Main Engine Screen, push the Menu button and select the “Display Controls” screens
near the bottom of the page.
1.6 Cleaning the Screen:
The MVP incorporates a flat panel full color TFT display, which should be protected from scratchs. The TFT
display should be cleaned using only isopropyl alcohol and a soft cleaning cloth. Individually wrapped lens-cleaning
tissue (used to clean glasses or plastic lenses) works best.
8
To Next Page
Loading...
Need help?
General
