8
Defining User Codes
System user codes are typically designated from MyELAS. They can
also be assigned from the control panel by the Master user.
To define user codes at the control panel:
1. Press , and then enter the master code (default is
1234) or the engineer code (default is 1111).
2. Use to scroll to 4. USER CODES, then press .
3. Use to scroll to the specific code slot that you
would like to assign, edit or delete (see chart above for the
available slots and their descriptions), and then press .
4. Scroll and select either: 1. EDIT CODE (to change or delete
a code) or 2.DESCRIPTOR (to change the code description
/ name), and then press .
5. Enter either the changed code or the changed code
description as follows:
• Use to move from character to character on
the display (or wait a second after entering a character to
automatically move to the next space).
• Press any button repeatedly to toggle between the letters
and number printed on it.
• Press to delete a character.
NOTE: If you want to delete a code, change it to 0000.
6. Press to confirm.
To Next Page
Loading...
