Eleglide M2 - Page 13

Tips:
1. When the locking function is activated, you'll need to enter the password to access to use of the
display. It is a 3-digit cord. The default password is 111.
2. To enter the password, press and to select the number for the current digit place and
double press the on/off button to move to the next digit place.
3. The password can only be altered via the Eleglide app.
4. If you forget the password, you can restore the factory settings via the Eleglide app. And the
password will be changed back to 111.
11
EN
Error Tracking
MODE
TRIP
km
Solutions
a.Replace the motor;
b.Replace the motor adapter cable;
c.Replace the controller;
a.Re-connect the display and controller;
b.Replace the display;
c.Replace the controller;
a.Charge the battery;
b.Re-connect the battery and the controller;
c.Replace the controller;
d.Replace the display;
a.Re-connect the controller;
b.Replace the controller;
a.Replace the motor;
b.Replace the motor adapter cable;
c.Replace the controller;
Causes
The motor is out of phase.
Communication error;
Under-voltage fault;
Controller fault;
Motor hall signal abnormality;
Error Codes
E01
E04
E08
E10
E40