EasyManua.ls Logo

Elektron Analog Four - Technical Information; Specifications

Elektron Analog Four
88 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
TECHNICAL INFORMATION
43
TECHNICAL INFORMATION
SPECIFICATIONS
THE SEQUENCER
4 synth tracks
1 FX track
1 CV/Gate track
128 patterns
Up to 64 steps per pattern
128 Sounds
128 Kits
16 Songs
6× arpeggiators
Individual track lengths
Swing, slide and accent functions
Track transpose
Micro timing
Parameter locks
Live friendly Performance mode
Sound-per-step change
Instant kit, pattern, track and Sound reload
Full real-time control
Full MIDI support
SEND EFFECTS
Wideshift Chorus
Saturator Delay
Supervoid Reverb
SYNTH VOICE (x4)
Fully analog signal path
2× analog oscillators
Variable waveshape on all waveforms
Oscillator AM and Sync modes
2× sub-oscillators
1× noise generator
1× 4-pole analog lowpass ladder filter
1× 2-pole analog multi-mode filter
1× analog overdrive circuit
Filter feedback
2× assignable LFOs
1× dedicated vibrato LFO
2× dedicated waveshape LFOs
1× amp envelope
2× assignable envelopes
2× dedicated LFO fade envelopes
1× dedicated noise fade envelope
1× dedicated vibrato envelope
1× dedicated autobend envelope
3x individual effect sends
ELECTRICAL SPECIFICATIONS
Impedance balanced audio outputs:
Headphones out level: +19 dBu (55 )
Main outputs level: +19 dBu
Output impedance: 440 unbalanced
Unbalanced audio inputs:
Input level: +19 dBu maximum
Audio input impedance: 9 k
Digital S/N ratio: 102 dBFS (20-20.000 Hz)
Unit power consumption: 8 W typical, 18 W maximum.
Recommended power supply: 6 V DC, 3 A
HARDWARE
122x32 pixel backlit LCD
MIDI In/Out/Thru with DIN Sync out
2 x 1/4” impedance balanced audio out jacks
2 x 1/4” audio in jacks
1 x 1/4” stereo headphone jack
2 x 1/4” dual CV/Gate outputs
48 kHz, 24-bit D/A and A/D converters
Flash-EEPROM upgradable OS
Electrically isolated USB 2.0 port
PHYSICAL SPECIFICATIONS
Steel casing
Dimensions: W340xD176xH63mm
(including knobs, jacks and rubber feet)
Weight: approximately 2.4 kg
POWER SUPPLY (PSU-3) ELECTRICAL SPECIFICATIONS
Input voltage range: 100-240V (43-60Hz)
Input connector: IEC320-C8 (2 prong)
In-rush current: 40-60 A maximum
Output voltage: 12 V DC
Output current: 2.5 A maximum
Output connector: 5.5x2.5mm DC plug, power at center
Ω
Ω
Ω

Table of Contents