Elid EL2305D - System Initialization

EL2305D Access Control Panel
User Guide
Revision 1.1.20
4
CHAPTER 1
1. SYSTEM INITIALIZATION
1.1 TO COLD START
Hold down keys "A” on the keypad and simultaneously switch off and then switch back on the
power supply. (Alternatively, hold down keys "A” on the keypad and press the reset switch while
power is on.)
Release the keys 3 seconds after the power supply is switched back on. If the cold start has been
properly performed, the display will be shown as below:-
If you press <#> , the screen changes to :-
Mas Eng Crd Disp
Crd Crd Typ Typ