Eliminator Lighting MEGA FLAT HEX PAK - System Menu Functions; Operating Modes Explained; DMX Mode Configuration

12
SYSTEM MENU
LED Display On/Off: To set the LED display to turn off after 10 seconds of inactivity, press the MODE
button until “don” is displayed, then press the UP button to scroll to “doff”. Now the display will disappear
after 10s of inactivity. Press any button to turn the display on again.
• “don” = LED display on at all times.
• “doFF” = LED display shuts off after 10 seconds of inactivity.
LED Display Inversion: Flip the display 180° so that the display can be read upside down.
1. Plug the xture in and press the MODE button until either “Stnd” or “rEv” is displayed. “Stnd” sets
the display in standard orientation, while “rEv” inverts the display.
2. Press the UP or DOWN buttons to toggle between the two options.
3. Press ENTER to conrm the option that you want to use.
Operating Modes: The Mega HEX Par has ve operating modes:
• DMX control mode - This function will allow you to control each individual xture’s traits with a
standard DMX 512 controller.
• RGBWA + UV Mode - Choose one of the six colors to remain static, or adjust the intensity of each
color to make a custom color.
• Sound-Active mode - The unit will react to sound, chasing through the built in programs. There are
16 sound active modes.
• Auto Mode - There are 33 Auto Modes to choose from: 16 color fade modes, 16 color change
modes, and 1 combination mode.
• Static Color Mode - There are 63 colors to choose from.
Static Color Mode:
1. Plug the xture in and press the MODE button until “CLXX” is displayed.
2. There are 63 colors to choose from. Select your desired color by pressing the UP and DOWN
buttons, then press ENTER to conrm.
3. Next, activate strobing by pressing the SET UP button to enter the Flash (strobe) mode. “FS.XX” will
be displayed, indicated that the unit is in Flash mode. The Flash can be adjusted between “FS.00”
(ash off) to “FS.15” (fastest ash).
Sound Active Mode: In this mode the Mega HEX Par will react to sound, and chase through the
different colors.
1. Plug the xture in and press the MODE button until “SoXX” is displayed. “XX” represents the sound
active mode (1-16) that is currently selected. Use the UP and DOWN buttons to scroll through the
sound active modes.
2. After you have found your desired sound active mode, press the SET UP button to adjust the sound
sensitivity. “SJ-X” will be displayed. Use the UP and DOWN buttons to adjust the sensitivity. “SJ-1”
is the lowest sensitivity, and “SJ-8” is the highest.
DMX Mode: Operating through a DMX controller gives the user the freedom to create custom programs
tailored to their own individual needs. The Mega HEX Par has 5 DMX modes: 6 Channel mode, 7
Channel mode, 8 Channel mode, 11 Channel mode, and a 12 Channel mode.
1. To run your xture in DMX mode, press the MODE button until “d.XXX” is displayed. “XXX” represents
the currently selected address. Use the UP or DOWN buttons to select your desired DMX address,
then press the SETUP button to select your DMX Channel mode.
2. Use the UP or DOWN buttons to scroll through the DMX Channel modes. Detailed information can
be found in the DMX Traits section of this manual. The Channel modes are listed below:
• Ch06 for 6-channel mode.
• Ch07 for 7-channel mode
• Ch08 for 8-channel mode
• Ch11 for 11-channel mode
• Ch12 for 12-channel mode
3. After you have chosen your desired DMX Channel mode, connect the xture to any standard DMX
controller via the XLR connections.