Elipson Chroma - VI. OPERATING INSTRUCTIONS; PLAYING VINYL RECORDS

36
IMPORTANT : SET YOUR AMPLIFIER ON A MODERATE VOLUME BEFORE PUTTING DOWN THE CARTRIDGE
ON THE DISC TO AVOID ANY DAMAGE TO YOUR SYSTEM.
• First of all be sure that the volume is at the minimum level.
• Place the disc on the felt, and make sure it is properly cleaned and dusted.
• Select speed according to the chosen disc (33 or 45 rpm).
• Remove the protection of the cartridge.
• Be sure that the cue lever lever is up. Then take out the tonearm from its support, place it at
the beginning of the disc and gently move down the cue control lever.
• Start playing.
At the end of the disc :
• Adjust the volume of your amplier.
• PMove up gently the cue control lever, and put back the tonearm on its support.
• Put the speed switch on “0”.
VI. OPERATING
NOTES
• The maximum range between the turntable and your wireless Bluetooth source is 10 meters
(without obstacles). If there are audio interruptions, please bring your Bluetooth source
closer to the turntable.
• There may be audio interruptions when your environment is lled with Wi.
• There may be audio interruptions if your Bluetooth devices perform other tasks (internet,
hard drive access...) at the same time they broadcast audio.
• Static electricity can disrupt the Bluetooth signal.
• After turning off the turntable, Bluetooth remains active for 2 minutes. If you want to pair
your wireless receivers to another source, 2 minutes of waiting will be needed.
If you have trouble pairing, check that there is no other device connected via Bluetooth. If
there is still trouble, you may need to reset the memory of the turntable.
• Plug in the turntable. Wait for 5 seconds.
The turntable’s blue LED ashes slowly (after a delay of 25 seconds).
• Press the pairing button for 3 seconds.
The turntable’s blue LED turns off.
• Press the pairing button for 10 seconds.
Pairing memory is now erased.
• Pair your devices like for a rst use.
If you still have trouble pairing despite these manipulations, press the pairing button during 3
seconds to turn off the Bluetooth. Press again on the pairing button during 3 seconds to turn
it on.
EN