Elite Screens AEON series - Support Bar Installation (Models >= 180); Support Bar Installation (Models 180-200); Corner Support Bar Installation (Models 180-200)

Rev.04/17/2017 DR www.elitescreens.com 8
Support bar installation (for models 180”- 200")
2. Position the center support bar (E) and M6 hex screws in the areas of the frame shown in fig 1. Align the hole on
each end of the support bar with the M6 hex screws located at the top and bottom frame sections. Then fasten with
the M6x12 screws.
1. Position the Corner support bars (M) and M6 Hex screws in the areas of the frame as shown below in fig
2. Align the holes on each end of the corner support bars with the M6 hex screws located on the vertical
and horizontal frame sections. Then fasten with the M6x12 screws.
Align the M6 Screws with
the two holes located on
the Center Support Bar.
Figure 1
Center Support Bar
Align the M6 Screws with
the two holes located on
the Center Support Bar.
Figure 1
Move the M6 hex screw to these areas of the frame.