Elite Screens AEON series - Installation Guidance for CineGrey 3 D ALR Screens; CineGrey 3 D ALR Screen Compatibility and Notes; Projector Alignment for ALR Screens

Rev.04/17/2017 DR www.elitescreens.com 9
Notice to Installer:
Please use the following installation instructions to obtain superior optical performance from the CineGrey 3D®
Angular Reflective ALR (Ambient Light Rejecting) Screen.
Make sure to follow these instructions in order for the CineGrey 3D® to perform correctly.
•Angular-Reflective material is not compatible with ultra/short-throw projectors
•Minimum lens throw ratio 1.5x image width
•Ambient light must not come from the same direction as the projector
Since angular-reflective means that the projected image will reflect at the mirror-opposite angle, it
is important to position the projector so that the viewer will get the best possible image.
Step 1: Establish the general “eye level” of the viewers
Step 2: Set the appropriate projection level
Step 3: Adjust the screen height level and projection angle
Input Angle (A) = Output Angle (B) aligns with the viewer’s angle
Figure 2
Corner Support Bar
Align the M6
screws with
the two holes
on the Corner
Support Bars.